The MODEL 400 is a rotating-case, rotating shell-plate design that is precision-machined from 6061 T6 aluminum. The .75 inch-thick top shell-plate is custom made for your choice of case sizes, one, two, three, or four holes in one plate. No additional shell-plates are required, just choose the correct size hole and adjust the torch height to match your case.
You decide which case sizes you want, at the same price. The top pictured below has four holes from .223 to .505 Gibbs, with an optional third torch ($45).
The thick shell-plate top acts as a massive heat-sink to protect the lower case body.
Continuous cartridge feeding allows you to anneal 100 cases in under 15 minutes, each with identical annealing and neck tension.
Correct torch angle is pictured above.
Cases rotate thru the dual flames as the shell-plate turns. Torch height is adjustable, as is torch angle and intensity. Torch holders will accept any 1/2" to 5/8" diameter tip.
After passing through the flame, cases drop out after a quarter-turn. The under-side cooling-fan can be turned on as needed when annealing shorter-height cases.
Torches are not included.
Model 400 Standard Unit-$495. Please contact us for ordering information.